The Grass Barrier Clamp Kit is used to connect one piece of Grass Barrier to another. This can be used to attach separate rolls together OR connect the ends of a round installation.


Supplies & Tools

Supplies & Tools
Needed Supplies: (2x) 7/16 wrench, Cordless drill, and a ¼” drill bit, will be needed to drill through the assembly and fasten the nuts and bolts.


Step 1

Step 1
Overlap both ends of the barrier, leaving enough to cover the width of the clamp.


wheel barrow and knee pads

Step 2
Align the Grass Barrier clamps on both sides of the material. To ensure the clamps are vertical, position the top of the clamps to the top of the barrier material.


Step 3
After clamps are aligned, position bit in the hole and drill through both sides of the barrier.


Step 4
Secure the first hole with the provided nuts & bolts, then drill the next hole and repeat.


wheel barrow and knee pads

Step 5
Secured clamps should appear as this. Clamps are on both sides of the barrier material and bolts are secured every two inches.